Peugeot 308 Key Fob Replacement
Peugeot's 308 might be somewhat old-fashioned but it's appealing. It might not be the plushest car in its class and the Ford Focus or Volkswagen Golf will help you stay away from imperfections on the road - but it's still a pleasant and a civilized drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is constant or intermittent these tips will assist.
Water Damage
If you leave your fob in a puddle or get it wet when kayaking, swimming, canoeing, rafting or canyoning, it's likely to suffer water damage. Keep your key fob in a dry bag whenever you are outside or perform activities that could expose it to a lot of water.
You'll also need to ensure that the fob is completely dry prior to opening it and re-using it. If you detect any odors from the fob (such as industrial liquid or windshield washer fluid), this is another indicator that it is submerged.
A wet circuit board can cause the battery to dump its charge or even explode. If you're able, if you can, pull your key fob 308 out of the water body it got stuck in then flip the button side down and shake it out as much water as you can before opening the case. Remove the battery, then clean the circuit board with a cotton swab that has been submerged in 90 percent alcohol.
Other reasons your Peugeot 308 remote entry keyless system might not function include a dead coin cell battery, receiver module problems, signal interference or a damaged chip. If none of the above are the reason it is possible to reset the system by disconnecting 12 volt battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system that lets drivers start their car from some distance, which allows them to warm up or cool down the car before they enter. This feature is extremely helpful particularly during the cold winter months. But sometimes, the remote stop system stops working due to a variety of causes, such as the battery of a coin that is dead.
The coin-shaped battery contained within the key fob may last between two and four years, based on how often it's utilized, the place it was purchased, and how it is used. The date for use-by is typically written on the package or marked in the manual.
If the key fob has stopped working after exposure to clean tap water and you want to remove the battery, clean the chip using a paper towel and isopropyl alcohol, then dry it thoroughly before replacing it. If the key fob was exposed to salty or soapy water, it could have fried the chip. It is necessary to replace it.
If you're not sure the battery is in good condition You can test the voltage with a multimeter that is set to the car's voltage range. Connect it to the minus and plus terminals. If the voltage is less than 12-13 volts, then you should replace the battery. You can also try to reset the on-board computer by disconnecting the battery with 12 volts for a couple of minutes, and reconnecting it in reverse order (positive cable first, then negative). The engine should start after this.
Faulty Receiver Module
If you're not seeing the "Key Detected" message on your dashboard, then it's possible that the receiver module has been afflicted with a fault. It's the part that transmits an alarm to the car when the key fob is activated which acts as an immobiliser. It stops it from starting until the correct key is present.
This could be due to a variety of factors including water damage or simply ageing. If the electronic chip inside your Peugeot 308 keyfob is damaged by dirty tap water, it could be because the keyfob was in contact with it. In peugeot boxer key fob is necessary to take the unit apart and clean it thoroughly using isopropyl alcohol, or electronic cleaner. Once it's dry, you can put the battery back in and try it again.
If the problem persists it is a good idea that you visit the local Peugeot expert or locksmith. They'll be able utilize a diagnostic tool to identify the issue and repair it for you.
It can be a stressful experience to lose your Peugeot car key. However, a qualified auto locksmith can address the issue in just a few minutes. They can cut a new key and programme it to your vehicle, ensuring that you're back out on the road as quickly as possible. Click here to find a locksmith near you.
Faulty electronic chip
The electronic chip in the Peugeot 308 key fob plays an essential function in the remote control system. If it becomes damaged, your car might not start or you might receive a message saying "anti-theft active". In this situation the only option is to replace the key. Luckily, professional auto locksmiths are able to provide this service in the shortest amount of time.
The chip in the key fob of your Peugeot 308 may become faulty for many reasons, such as water damage, sweat or dirt. If your Peugeot key fob has been exposed to soapy or dirty water, it should be cleaned immediately. You can clean the electronic component with the help of a towel that is soaked in isopropyl Alcohol. The battery should then be allowed to completely dry.
Radio interference can cause the key fob to stop functioning. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. This can be caused by problems with the environment or objects within the vicinity of the vehicle. If you have this issue, it is best to visit a Peugeot dealership.
The Peugeot 207/308 Key Fob is delicate and needs special attention. It is imperative not to throw or drop the key fob. If you lose something, try to find it as soon as possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a short period of time. Disconnect the negative cable before the positive.